New Fence Installation in St. George, UT

A new fence is a big job. The company should measure, check your property line, pull the permit if one is needed, and set posts deep enough to stay straight.

  • Block or masonry wall. Block walls are common in the desert and handle sun well. Walls 4 ft or taller used as retaining walls need a permit.
  • Vinyl privacy fence. Vinyl holds up in heat and does not need staining.
  • Wrought iron or aluminum fence. Open fences fit the front yard rule that requires at least 50 percent open near the sidewalk.
  • Wood privacy fence. Fits the 6 ft 4 in side and rear limit, but needs regular sealing in strong sun.
  • Chain link fence. A low-cost choice for big lots and pets.

Intense sun fades and dries out wood, so stain or sealer helps.

Vinyl and metal handle heat well but can expand and shift in strong sun.

Get matched with a St. George fence company

Free. One company calls you, not ten.

By sending this, you agree we may share your details with one local fence company so they can contact you about your project. We don't sell your details to anyone else. Privacy

Typical prices in St. George

JobTypical rangeBasis
Wood privacy fence, per linear foot installed (6 ft)$25-$50national 2025
Privacy fence, per linear foot installed (all materials)$10-$50national 2025
Whole wood fence job, typical total$3,500-$6,500national 2025
Whole vinyl fence job, typical total$4,000-$7,300national 2025
Whole chain link fence job, typical total$2,450-$4,000national 2025

Ranges, not quotes. Your price depends on the job.

St. George rules that apply

A permit is required before you build any fence in a front setback, unless the fence is shown on an approved site plan. You send a site plan with property lines, sidewalks, buildings, and fence heights and locations. Check with the St. George Building Department about side and rear yard fences.